Sectors - ConsuLab

JavaScript desactivated

As much as this website's been tested without JavaScript, some features will require JavaScript. Please turn on your JavaScript.

Get a quote

AE-71-MK USCOPE DIGITAL STORAGE OSCILLOSCOPE - MASTER KIT + Add to wishlist

AE-71-MK_053280

The uScope Master Kit is a single channel, pocket-sized, digital storage oscilloscope (DSO) that is small, quick, and powerful enough to capture the fastest signals when connected to ConsuLab trainers or other signals. In less than 4 seconds it’s booted up and ready to take aim on any signal. The Master Kit includes a comprehensive selection of common accessories and test leads needed for labscope diagnostics. The uScope is equipped with a 12-bit analog/digital converter, samples at 1 million/second and includes 10x peak detect oversample. An optional signal harness for multiple user access is available on request. The Master Kit contains additional probes, adapters, Amp-Clamp, Ignition adapters, and other accessories for those needing them. Be aware that most other scope and DMM accessories can also be used with the uScope.

Educational Advantages

Although physically small, the uScope has many features equal to much more expensive units.
The uScope has internal preset stored sample patterns for sensors, actuators, amp, ignition and charging system patterns for student reference. Patterns can be over-layed with live pattern for comparisons.
The uScope has a built in 10Hz-1MHz square wave signal generator for student learning and practice. The signal is manually adjustable for duty cycle and frequency.
Obtained waveforms can be saved and stored on a computer for future recall and instruction.
Being extremely affordable, multiple units can be purchased for groups of students all viewing one signal with the optional signal distribution harness.

Kit Contents

uScope Digital Storage Oscilloscope
Protective boot (orange)
Low Current Amp Probe (10mA - 60A)
Shielded test lead (5-ft)
Secondary lead (5-ft) with COP paddle and plug wire clamp
AC filter
Primary ignition probe (attenuator)
Alligator clips (black & green)
2mm pin tip probes (black & green)
EAP backpinning probes (2)
Adapter for BNC connector
Adapter for banana plug
2GB micro SD card
Micro USB cable
3.5mm mini phono plug for signal generator
Hard carrying case
User manual (PDF file will be emailed)

You must be connected to access this section. Please register or, if you already have an account, login.

You must be logged in to write a review about our products.

Testimonials

I got the half car out of the crate and working yesterday and today I had my Level 3 Electronic Climate Control diagnostics lab using it. This teaching aid is great! The workmanship and design is excellent and it is just perfect for the Level 3 curriculum, including the upcoming changes. We were fortunate that the IPro scan tool we received from the Uniselect donation communicates quite well with the Audi CAN bus system. The Audi also has the electronically controlled, clutchless compressor which is covered in our theory classes so it's a good reinforcement to be able to see it in action, manipulate it and communicate with it. I am very pleased with the quality and applicability of our ConsuLab products (including the engine/AC bench we got recently). They allow me to teach up to 8 students in great detail, whereas only one or two at a time can be involved in a full car. I am looking forward to the imminent arrival of our AC board. Thanks for your excellent insight of design and quality of manufacturing.

Prof. Thomas Brown, Centennial College